Siemens Unix V4.0 Overviews & Installation Instructions page 71

Installing Advanced Server for UNIX
If the server is not started, the following message gives you information on how to upgrade
later:
Access Control Entries can be upgraded from the LAN Manager 2.x accounts
file (/var/opt/lanman/datafiles/accounts.lm2) after the user accounts and
groups have been replicated to this backup controller.
You will need to manually run lmxupgrade -A ... after this has occurred.
In this case, the administration files must be adjusted after Advanced Server for UNIX has
been started.
Ê Start AS/X with asx start.
Ê Use the net user command to check whether the account data has already been trans-
ferred to this backup domain controller. If it has not been transferred, you can start the
transfer using the command net accounts /sync. If there are problems transferring the
account data, you may have to call /var/opt/lanman/bin/joindomain to re-establish the
connection again.
If the account data has been updated on this backup domain controller, the access
Ê
permissions must be created for Advanced Server for UNIX. Call
/var/opt/lanman/bin/lmxupgrade -YA.
Watch the output of the command for files and directories which are not found for
upgrading access permissions.
4.8.4 Upgrade installation of a primary domain controller from
Version 3.5 or 4.0
To upgrade a primary domain controller from a previous Advanced Server for UNIX version,
proceed as follows. In contrast to an upgrade installation from Version 2.x, the data can be
upgraded directly; no conversion has to be done.
Log on as system administrator root.
Ê
Start the installation procedure as described in the section
Ê
cdinst".
Ê Select the asxserver package under AS/X.
Stop the server
Ê Choose y to stop the server.
Product Manual
Installing server software (asxserver package)
"Installing from CD-ROM with
U7613-J-Z815-6-76