Siemens Unix V4.0 Overviews & Installation Instructions page 135

Configuring Advanced Server for UNIX
net start server command
You can start the Advanced Server for UNIX processes of the server with the net start server
command if you have stopped the server with net stop server beforehand for example. You
can thus activate a new configuration for example.
/etc/init.d/ms_srv start
The /etc/init.d/ms_srv start script is used to start all server processes in the background;
there will be a delay before connections with Advanced Server for UNIX are set up.
5.7.3 Sharing resources
For information on how to share resources, please refer to
manual.
5.7.4 Terminating Advanced Server for UNIX
The following commands are available for terminating Advanced Server for UNIX:
– asx start
– net start server
– /etc/init.d/ms_srv start
asx stop command
The asx stop command is used to terminate Advanced Server for UNIX, the NetBIOS admin-
istration process and other processes which were initiated using the asx start command.
!
net stop server command
You can terminate the Advanced Server for UNIX processes of the server using net stop
server without terminating the other processes that have been started with asx start at the
same time (e.g. NetBIOS). In this case, you should only start the Advanced Server for UNIX
processes with net start server. You can thus activate a new configuration for example.
Product Manual
(all processes, including NetBIOS and WINS)
(the server only)
(the server only; in the background)
This command stops the server without further queries even if connections still
exist!
Activating Advanced Server for UNIX
"Concepts and Planning"
U7613-J-Z815-6-76