Table of Contents
Advertisement
4. Change the installation position of switch
When install the sliding table, you must
change the installation position of the
switch, you can install the magnetic
switch onto the bottom of the sliding
table with three sets hex bolts, as
shown in Fig.3
M6-1x 12 hex bolts........3
6mm lock washers.........3
6mm flat washers..........3
Fig.3
5. About Rail
Due to the installation of the sliding table, we provide the short guide, the explosion diagram
and parts list of short guide, please see attachment file.
NOTE:
If the fence rails on your saw prevent is as Fig.4, you need to cut off the left ends of
the rails, as Fig.4 point;
(or re-mount the rails farther to the right, which may also require you to drill new
holes in your table and cut small notches into your rails for access to t-slots in your
saw's table as Fig.5)
Next, you may need to re-mount the power switch to a new location, as Fig.3;
、
Fig.4
Fig.5
Advertisement
Table of Contents
