Cleaning - Sonoro LOUNGE SO-320 Operating Manual

Malfuntion
Remote control does not work
correctly or does not work at all
Alarm does not work
Alarm light does not work.

19. Cleaning

NOTICE!
Material damage from improper cleaning!
Only clean the device from the outside using a dry, soft cloth. Never use abrasive or
solventbased cleaning agents as these may damage the surface of the device.
© sonoro audio GmbH 2018
Possible Causes
Distance is too great
The battery is empty
Interference caused by other radio
transmitters or devices
Alarm is not switched on
Alarm volume is set to minimum
Headphones are connected
sonoroLIGHT is not connected.
sonoroLIGHT is connected but the
dimmer function is switched off.
The lamp connected to sonoro-
LIGHT is switched off.
Elimination
Reduce the distance between the
remote control and the device.
Exchange the battery in the remote
control (see Chapter 7.5
'Preparing the remote control' on
page 66).
Increase the distance between the
source of interference and the
LOUNGE. Connect the device to a
different socket, so that the source of the
interference and the LOUNGE are
connected to different branch circuits..
Switch the alarm on (see Chapter 9.6
'Switching the alarm function on/off' on
page 81)
Increase the volume (see Chapter 9.3
'Setting the alarm volume' on page 79).
Remove the headphones from the socket.
Connect sonoroLIGHT and set the
alarm light (see Chapter 9.5
'Programming the alarm light
(sunrise)' on page 80).
Switch on the dimmer function on
sonoroLIGHT.
Switch the connected lamp on.
GB
101