Gigaset 108 Owner's Manual page 54

Configuring the Advanced Settings
Channel
This function is only shown in the window if the Super G transmission mode is deacti-
vated (see page 54).
The set radio channel is used by all clients in your network for wireless data transfer. You
can choose between various channels, depending on your current location.
ì
In the Repeater operating mode, set the channel that uses the access point for which
you wish to increase the range.
ì
Select Automatic in the Access point operating mode so that the best channel for
transmitting the data is used automatically.
SSID
Before the wireless network components can communicate with each other, you must
use the same SSID (Service Set Identifier).
The Gigaset WLAN Repeater 108 SSID factory setting is ConnectionPoint. For the
repeater, you must enter the SSID of the access point for which the range should be
increased. For security reasons you should deactivate SSID broadcast (see below).
ì
Enter the required SSID. The SSID is case sensitive. It can be up to 32 alphanumerical
characters long.
Please note:
The connection to the wireless network adapters will be interrupted until you
enter the new SSID on them as well.
52