Siemens SPC3 Hardware Description page 7

7.1.6 Interface Signals
7.2 UART
7.3 ASIC Test
8 TECHNICAL DATA
8.1 Maximum Limit Values
8.2 Permitted Operating Values
8.3 DC-Specifikation of the I/O- Drivers
8.4 AC-Specification for the Output Drivers
8.5 Timing Characteristics
8.5.1 SYS Bus Interface
8.5.2 Timing in the Synchronous C32-Mode:
8.5.3 Timing in the Asynchronous Intel Mode (X86 Mode) :
8.5.4 Timing in the Synchronous Motorola Mode (E_Clock-Mode, for example, 68HC11) :
8.5.5 Timing in the Asynchronous Motorola-Mode (for example, 68HC16) :
8.5.6 Serial Bus Interface
8.5.7 Housing
8.5.8 Processing Instructions
9 PROFIBUS INTERFACE
9.1 Pin Assignment
9.2 Example for the RS 485 Interface
10 APPENDIX
10.1 Addresses
10.2 General Definition of Terms
10.3 Ordering of ASICs
10.3.1 SPC3 (AMI)
10.3.2 SPC3 (ST)
11 APPENDIX A: DIAGNOSTICS PROCESSING IN PROFIBUS DP
11.1 Introduction
11.2 Diagnostics Bits and Expanded Diagnostics
11.2.1 STAT_DIAG
11.2.2 EXT_DIAG
11.2.3 EXT_DIAG_OVERFLOW
11.3 Diagnostics Processing from the System View
12 APPENDIX B: USEFUL INFORMATION
12.1 Data format in the Siemens PLC SIMATIC
SPC3 Hardware Description
Copyright (C) Siemens AG 2003 All rights reserved.
SPC3
V1.3
PROFIBUS Interface Center
43
43
43
44
44
44
44
45
46
46
47
49
50
52
54
55
56
57
57
58
59
59
60
60
60
60
61
61
61
61
61
63
63
64
64
Page 5
2003/04