Suds Cooling; Low Water Pressure; Anti-Crease; Delay Start - Miele WMR 861 WPS Operating Instructions Manual

Settings

Suds cooling

When this is activated, additional
water flows into the drum at the end of
the main wash to cool the suds down.
Hot suds can damage plastic drainage
pipes.
Suds cooling takes place when a
Cottons programme with a temperature
of 70°C or higher is selected.
Suds cooling should be activated:
– to prevent the danger of scalding if
the drain hose is hooked over the
edge of a sink or basin.
Factory default setting: Suds cooling is
switched off.

Low water pressure

If the water pressure is below 100 kPa
(1 bar), the programme will be
cancelled and the fault message
intake fault will appear.
If the on-site water pressure cannot be
increased, activating this function will
prevent the programme from being
cancelled.
Factory default setting: Low water
pressure is switched off.
110

Anti-crease

The Anti-crease function helps prevent
creasing if laundry is not going to be
removed immediately after the end of
the programme.
The drum continues to turn at intervals
for up to 30 minutes at the end of the
programme. The door can be opened at
any time.
Factory default setting: Anti-crease is
switched off.

Delay start

For specifying which time prompt
should appear with the Delay start
function.
Options
– Start at
With the Delay start function you
Water
specify at what time the wash
programme should begin.
– Finish at (Factory default setting)
With the Delay start function you
specify at what time the wash
programme should end.