Table of Contents
Advertisement
Programmable functions
Suds cooling
When this is activated, additional wa-
ter flows into the drum at the end of
the main wash to cool the suds down.
Hot suds can damage plastic drainage
pipes.
Suds cooling takes place when a tem-
perature of 70 °C or higher is selected
for the Cottons programme.
Suds cooling should be activated:
- to prevent the danger of scalding if
the drain hose is hooked over the
edge of a sink or basin.
- where drainage pipes do not comply
with DIN 1986.
Options
= Suds cooling is switched off
(factory default setting)
= Suds cooling is switched on
Low water pressure
If the water pressure is below 100 kPa
(1 bar), the washing machine cancels
the programme and the fault mes-
sage appears.
If the water pressure cannot be in-
creased, activating this function will pre-
vent the programme from being can-
celled.
Options
= Low water pressure is switched
off
= Low water pressure is switched
on (factory default setting)
82
Anti-crease
The anti-crease function helps prevent
creasing if laundry is not going to be
removed immediately after the end of
the programme.
The drum continues to turn at intervals
for up to 30 minutes at the end of the
programme. The door can be opened at
any time.
Options
= The anti-crease function is
switched off
= The anti-crease function is
switched on (factory default
setting)
Backlight brightness
dimmed
The brightness of the dimmed sensors
in the control panel can be set to one
of seven different levels.
The brightness changes as soon as you
select a different setting.
Options
= Darkest level
= Lightest level
= (Factory default setting)
Advertisement
Table of Contents
