Table of Contents
Advertisement
Installation requirements
Low water pressure
If the water pressure is below 100 kPa
(1 bar), the programme will be can-
celled and a fault message will appear.
If the on-site water pressure cannot be
increased, activating this function will
prevent the programme from being can-
celled.
Low water pressure is activated as
standard.
Suds cooling
Additional water flows into the drum at
the end of the main wash to cool the
suds down.
Suds cooling takes place when a Cot-
tons programme with a temperature of
70 °C or higher is selected.
Suds cooling should be activated:
- to prevent the danger of scalding if
the drain hose is hooked over the
edge of a sink or basin.
- where the drainage pipes do not
comply with DIN 1986.
Suds cooling is deactivated as stand-
ard.
Temperature reduction
At high altitudes water has a lower
boiling point. Miele recommends ac-
tivating the reduced temperature set-
ting at altitudes of 2000 m or above to
prevent water from boiling. The max-
imum temperature is reduced to 80 °C
even if a higher temperature is selec-
ted.
Temp. reduction is deactivated as
standard.
Settings
113
Advertisement
Table of Contents
