Wire The Removable Terminal Block - Allen-Bradley ControlLogix 1756-OF6CI Installation Instructions Manual

Wire the Removable Terminal Block

:LUH WKH 57% EHIRUH LQVWDOOLQJ LW RQWR WKH PRGXOH 8VH D  LQFK PP PD[LPXP
IODWEODGHG VFUHZGULYHU
,03257$17 3XOO WKH KRXVLQJ RII RI WKH 57% EHIRUH ZLULQJ
6KLHOGHG FDEOH LV UHTXLUHG ZKHQ XVLQJ WKLV PRGXOH :H UHFRPPHQG XVLQJ %HOGHQ  FDEOH
WR ZLUH WKH 57% 7KH 57% WHUPLQDWLRQV FDQ DFFRPPRGDWH  JDXJH VKLHOGHG ZLUH
Connect grounded end of the cable
 *URXQG WKH GUDLQ ZLUH
,03257$17 :H UHFRPPHQG JURXQGLQJ WKH GUDLQ ZLUH DW WKH ILHOGVLGH ,I \RX FDQQRW
JURXQG DW WKH ILHOGVLGH JURXQG DW DQ HDUWK JURXQG RQ WKH FKDVVLV DV VKRZQ EHORZ
a. Remove a length
of cable jacket
from the
connecting cable.
e. Connect the drain wire to a
chassis mounting tab.
Use any chassis mounting
tab that is designated as a
functional signal ground.
 &RQQHFW WKH LQVXODWHG ZLUHV WR WKH ILHOGVLGH
Connect ungrounded end of the cable
 &XW WKH IRLO VKLHOG DQG GUDLQ ZLUH EDFN WR WKH FDEOH FDVLQJ DQG DSSO\ VKULQN ZUDS
 &RQQHFW WKH LQVXODWHG ZLUHV WR WKH 57% VHH SDJH  
b. Pull the foil shield
and bare drain
wire from the
insulated wire.
Chassis mounting tab
Drain wire with ground lug
ControlLogix Current Loop Output Module
c. Twist the foil shield
and drain wire
together to form a
single strand.
Publication 1756-5.36 - September 1999
d. Attach a ground lug
and apply heat
shrink tubing to the
exit area.
20918-M
4M or 5M (#10 or #12)
star washer
4M or 5M (#10 or #12)
phillips screw and star
washer (or SEM screw)
7
20104-M