Using A Handset As A Room Monitor - Siemens Gigaset SL 740 Operating Manual

Using a handset as a room
monitor
With this function, a previously stored
internal or external number is called when
a set noise level in the room is reached.
The room monitor remains activated on
the handset even after you hang up.
The handset should be between 1 and
2 metres away from the baby. The
microphone must be directed towards the
baby.
When the room monitor is activated,
incoming calls to the handset which is
near the baby are indicated without a
ring tone, they are just shown on the
display. The display and the key pad are
not illuminated.
When entering an external telephone
number, make sure:
u
The handset must not be blocked for
outgoing calls.
u
The number to which the room
monitor call is forwarded must not be
blocked by an activated answering
machine.
u
Always check the settings of the
room monitor before you leave
home. For example, test its
sensitivity. Check the phone line if
the room monitor is redirected to an
external number.
u
A room monitor stops calling an
external number after around
90 seconds. Room monitor calls to an
internal number (handset) stop after
about 3 minutes.
u
The activated room monitor function
reduces the handset operating time
considerably. Place the handset in the
charger to prevent the battery from
going flat.
u
The room monitor function can also be
used in Walk and Talk mode (p. 45).
Operating more than one handset
Activating the room monitor function
and entering the "call to" number
Step 1: Open input field for room monitor:
¢ ¢
v í
Room Monitor
Step 2: Activate room monitor:
r
In Room M.: select On.
Step 3: Enter the "call to" number:
s
Scroll to the Call to: line.
Press the display key. The input
Edit
field for the phone number is
opened.
Enter an external number as the "call to"
number:
s/~
Enter or select number from
the directory.
Only the last four digits are
displayed.
©
Press the display key.
Save Entry Select and press
is stored.
You can also enter an internal number as
the "call to" number:
handset) .
OK
Step 4: Set the sensitivity:
s
Scroll to the Level: line.
r
Select sensitivity for the noise
level (Low or High).
Press the display key. The
Save
room monitor function is now
activated.
Once the room monitor is activated,
switch directly to the room monitor
setting with v (open menu).
. The entry
OK
¢
s (Select
INT
43