JVC KD-SH1000 Instruction Manual page 179

ELECTRICAL CONNECTIONS
A
Typical connections /
Before connecting: Check the wiring in the vehicle carefully. Incorrect connection may cause serious
damage to this unit.
The leads of the power cord and those of the connector from the car body may be different in color.
1
Connect the colored leads of the power cord in the order specified in the illustration below.
2
Connect the antenna cord.
3
Finally connect the wiring harness to the unit.
If you have installed 3-way network speaker system in your car, see diagram
connection.
To subwoofer (see diagram
Antenna connector
Rear ground terminal
Line out (see diagram )
To external components (see diagram
* 4
Not supplied for this unit.
* 4
* 5
Before checking the operation of this unit prior to
installation, this lead must be connected, otherwise power
cannot be turned on.
* 5
White with black stripe
Left speaker (front)
E-C Instal1-3_SH100#16CE4C.indd 3 E-C Instal1-3_SH100#16CE4C.indd 3
All manuals and user guides at all-guides.com
for speaker
)
)
LINE IN
(see diagram /
15 A fuse
15 A
Black
* 5
Yellow
* 5
Red
Blue
)
)
Blue with white stripe
Orange with white stripe
Brown
White Gray with black stripe
Right speaker (front)
1
2
3
)
To metallic body or chassis of the car
To a live terminal in the fuse block connecting to the car battery (bypassing the
ignition switch) (constant 12 V)
12 V
To an accessory terminal in the fuse block
To automatic antenna if any (250 mA max.)
To the remote lead of other equipment (200 mA max.)
Gray Green with black stripe
3
Fuse block
250 mA
200 mA
To car light control switch
To cellular phone system
Green Purple with black stripe
Left speaker (rear)
Ignition switch
Purple
Right speaker (rear)
14/2/06 2:50:22 PM 14/2/06 2:50:22 PM