JVC KD-SH1000 Instruction Manual page 128

• "SD Loading Error" appears on the display
while playing tracks from an SD card.
• While playing a track, sound is sometimes
interrupted.
• Correct characters are not displayed (e.g.
album name).
• "No Disc" appears on the display.
• "No Magazine" appears on the display.
• "Reset 8" appears on the display.
• "Reset 1" – "Reset 7" appears on the display.
• The CD changer does not work at all.
• DSP mode cannot be selected other modes
than "Defeat."
• Only high range sound or low range sound is
reproduced though full range speakers are
connected.
• The iPod or D. player does not turn on or does
not work.
• Buttons do not work as intended.
• The sound is distorted.
• "Disconnect" appears on the display.
• Playback stops.
34
All manuals and user guides at all-guides.com
Symptoms Remedies/Causes
Detach the control panel and reinsert the SD card. The
control panel goes back to initial position (Angle 1).
MP3/WMA tracks have not been properly copied into the
device.
Copy MP3/WMA tracks again into the device, and try
again.
This unit can only display letters (capital: A – Z, small:
a – z), numbers, and a limited number of symbols and
special characters (see page 31).
Insert a disc into the magazine.
Insert the magazine.
Connect this unit and the CD changer correctly and press
the reset button of the CD changer.
Press the reset button of the CD changer.
Reset the unit (see page 2).
Deactivate crossover network (see page 18).
• Check the connecting cable and its connection.
• Update the firmware version.
• Charge the battery.
The functions of the buttons have been changed. Press
POWER/ATT/ENTER before performing the operation.
Deactivate the equalizer either on the unit or the iPod/
D. player.
Check the connecting cable and its connection.
The headphones are disconnected during playback. Restart
the playback operation using the control panel (see page
24).