JVC KD-SH1000 Instruction Manual page 178

INSTALLATION (IN-DASH MOUNTING)
The following illustration shows a typical installation. If you have any questions or require information
regarding installation kits, consult your JVC car audio dealer or a company supplying kits.
• If you are not sure how to install this unit correctly, have it installed by a qualified technician.
1
* When you stand the unit, be careful not to damage the fuse on the rear.
1
*
Removing the unit
Before removing the unit, release the rear section.
When using the optional stay /
Fire wall
Dashboard
Install the unit at an angle of less than 30˚.
Caution when installing /
E-C Instal1-3_SH100#16CE4C.indd 2 E-C Instal1-3_SH100#16CE4C.indd 2
All manuals and user guides at all-guides.com
When installing the unit without using the sleeve /
In a Toyota car for example, first remove the car radio and install the unit in its place.
(TOYOTA)
Stay (option)
Flat type screws (M5
Screw (option)
Note
30˚
Fit the unit into the mounting sleeve by using four corners of the trim plate.
• DO NOT press the panel (shaded in the illustration).
•
Do the required electrical connections.
2
* Fit the protrusions outside the unit.
* 2
Insert the two handles, then pull them
as illustrated so that the unit can be
removed.
× * 3
8 mm)
* 3
(M5 × 8 mm)
* 3
Bracket
* 3
Pocket
*
Bracket 3
* 3
: When installing the unit on the mounting bracket, make sure to use the 8 mm-long screws. If longer screws are
used, they could damage the unit.
:
8 mm
2
JVC
Bend the appropriate tabs to hold the
sleeve firmly in place.
* 3 Not supplied for this unit.
* 3
× * 3
Flat type screws (M5 8 mm)
* 3
(M5 × 8 mm)
14/2/06 2:50:20 PM 14/2/06 2:50:20 PM