Assembling The Selfie Stick; Attaching A Smartphone To The Selfie Stick - Silvercrest SSP 2600 A1 Operating Instructions Manual

♦ If you want to stop the Bluetooth
with your selfie stick, for instance, to separate the
devices, press the On/Off button
The Bluetooth
charging status LEDs
after about 30 seconds. The Bluetooth
is now turned off.
NOTE
► Press and hold the On/Off button
stick for 2 seconds to turn on the Bluetooth
function. The Bluetooth
approx. 7 seconds.
The charging status LEDs
go off after about 30 seconds. The devices are
now connected via Bluetooth
to confirm the Bluetooth
smartphone.
Assembling the selfie stick
♦ Screw one of the threads on the mount
thread of the tripod head
mount
position using the fastening screw
♦ Push the telescopic shaft
selfie stick handle. Turn the telescopic shaft
wise a little until the telescopic shaft
the selfie stick. The telescopic shaft
selfie stick are now connected to each other.
Attaching a smartphone to the selfie stick
♦ Open the mount
♦ Place your smartphone into the mount
♦ Release the clip so that the clip snaps onto your
smartphone. Ensure that your smartphone is firmly
in place in the mount
♦ Set the vertical tilt angle of the smartphone. Loosen
the fastening screw hinge joint
turning it anticlockwise. Lock the smartphone into
this position by turning the fastening screw hinge
joint clockwise.
♦ Set the horizontal alignment of the smartphone.
Undo the fastening screw
ing it to the right. Turn the fastening screw
left to lock the smartphone into this position.
■ 10
│ GB
LED
®
vertically or horizontally. Fix the required
by pulling the spring clip open.
®
flashes 3 times. The
light up and then go off
LED lights up for
®
light up and then
. You may have
®
connection on your
®
. You can assemble the
into the holes on the
.
on the mount by
on the mount by turn-
SSP 2600 A1
connection
for 2 seconds.
function
®
of the selfie
®
onto the
.
clock-
clicks into
and the
.
to the