Stanley K100 Installation And Operating Instructions Manual page 15

To set the starting time for Programme P1,
press "set". The display starts to flash. Press
the "+" or "-" key to select the time and then
press "ok" to confirm. Press the "+" key to go
to the P1 ." Stop" menu.
To set the stopping time for Programme P1,
press "set". The display starts to flash. Press
the "+" or "-" key to select the time and then
press "ok" to confirm. Press the "+" key to go
to the "Air Temperature "menu.
To set the set point temperature for
Programme P1, press "Set". The display starts
to flash. Press the "+" or "-" key to select the
desired temperature, followed by "Ok" to con-
firm.
To set the operating power level (1 to 5) of
Programme P1, press "Set". The display starts
to flash. Press the "+" or "-" key to select the
desired power level (1 to 5), and then "Ok" to
confirm. Press the "+" key to go to the "Days"
menu.
To select the days of the week that you want
P1 Programme to run, press "set" and then
select the day of the week using the "-" and "+"
keys. Press "set". The display starts to flash.
Select "On" or "Off" using the "-" and "+" keys.
Press "ok" to confirm the selection. Press the
"esc" key to go to the "Days" menu. Press the
"esc" key again to go to the "program " menu.
Press the "+" key to move on to the next
menu.
Repeat the steps to set up Programs P2 to P6
or as many as are required.
Once the programs are set remember to
15