Table of Contents
Advertisement
INSTALLING DRIVERS FOR NON-UIP HSPA+ DEVICES
Installing on Windows XP
This process installs four drivers.
Note:
If you previously installed USB drivers for this device, uninstall them before installing or re-installing this
driver. Uninstall all existing drivers for this device. Refer to Uninstall Windows Drivers for details.
Before you connect the device (disconnect the device if you connected it):
1.
Go to the location where you extracted the driver and open the H5-USB\Driver folder.
2.
Right-click on TelitUSBInstaller_In_U8.00.04.exe and select Run.
3.
Click Next and follow the instructions in the installation wizard.
4.
Click Continue Anyway each time this screen appears.
5.
Click Finish.
6.
Connect USB cable from the device to a USB port on your computer. After it detects the hardware,
Windows opens the New Hardware Wizard.
7.
Select No, not this time and click Next.
8.
Select Install the software automatically (Recommended) and click Next.
9.
Select Finish.
10.
Repeat Steps 7-9 for each additional New Hardware Wizard. Windows indicates when the device is ready
to use.
11.
Signal strength LEDs require a device reboot after installing software. Disconnect the device from the
computer's USB port for a few seconds and reconnect the device to the same USB port.
66
TM
MultiConnect
PCIe MTPCIE-H5/MTPCIE-BW Developer Guide
Advertisement
Table of Contents
Need help?
Do you have a question about the MultiConnect MTPCIE-H5 and is the answer not in the manual?
Questions and answers