Slnet Busy Lamp Information - NEC SL2100 Quick Install Manual

Configure the SL2100

SLNet Busy Lamp Information

The system can show the BLF state of an extension connected to another SLNet system in the network. The
state can be shown at either a DSS console or programmable function key set to DSS type.
Maximum value = 64800 (6480 Seconds).
Setting the value to zero disables the sending of SLNet Busy Lamp Information.
The recommended setting is 20 (2 Seconds).
The same value should be set at all systems that are setup to send Busy Lamp Information.
Enter the refresh interval
(value x 100 mS)
Quick Install Guide – SL2100 SLNet rev1.0
31