What Is The Sl2100; Slnet Included In This Guide - NEC SL2100 Quick Install Manual

NEC SL2100 Communication System

What is the SL2100?

The SL2100 system consists of a chassis unit with a dedicated slot for the CPU
card and four universal slots for interface cards. Each universal slot supports an
extension interface card, optionally each extension interface card can have a trunk
interface daughter card mounted.
The chassis unit is ventilation cooled (no fan) and can be wall mounted or rack
mounted with the optional rack mount shelf.
Up to three chassis units can be connected together to provide a total of twelve
universal slots.
Interface cards are available for Analogue and ISDN trunks, proprietary SL2100
terminals and analogue telephones.
SIP Trunks, SLNet and IP terminals are supported without the need for additional
system hardware as eight VoIP resources are built in to the CPU card. VoIP
resources can be expanded to 16 by adding the optional VOIPDB card and further
to 128 with licenses.
InMail voicemail is also available either using the built in storage of the CPU-C1-A or by adding the optional SD
card.
The built in InMail with the CPU-C1-A card provides 4channels and 2hours of storage, this can be expanded to
15hour or 120hour by adding the SD card to the CPU.
The CPU-C1 requires the SD card installed to provide InMail voicemail.
Both CPU's have built in VRS with 4 channels and 100 messages with 2hours message storage.
All equipment will operate in the default/factory setting when the SL2100 is installed.
With the default settings:

Each telephone will function and is assigned an extension number.

Calls received on the trunk lines will ring at telephone number 200.

Each telephone can make outside calls by dialling 9.

Each trunk line is presented at a Function Key with busy lamp indication.

SLNet is not configured

SLNet included in this guide

Only the configuration of SLNet is covered in this guide.
SLNet provides these networking features:

Centralised InMail voicemail

Desk to Desk calling with Caller ID and name display

Sharing trunk lines with remote systems

Extension busy lamp information

Shared Park Hold orbits
SLNet is available for SL2100 systems only, each system should have the same level of Main Software installed.
SLNet is supported with Main Software R1.5 or later.
Quick Install Guide – SL2100 SLNet rev1.0
4