5- Configure The Sl2100; Connecting Pcpro To The Sl2100 - NEC SL2100 Quick Install Manual

Configure the SL2100

5- Configure the SL2100

This Quick Install guide will cover SLNet configuration. For other system configuration please refer to the
relevant SL2100 Quick Install Guide.
You must have SL2100 PCPro installed to your laptop/PC, this can be downloaded from BusinessNet, refer to
the Quick Install Guide – SL2100 PCpro.
Note - SLNet can only be configured via SL2100 PCPro, System phone or WebPro interface is not
currently available for SLNet items.
Before you configure your system it is important that you:

Have a diagram of your SLNet nodes and the exchange lines and telephones at each node.

The IP addresses and numbering plan of each node (extension numbering must be unique at each
node)

Plan your requirements before you start.
While you configure your system it is advised that you:

Make a record of your configuration as you make each change.

Make small changes, upload to the SL2100 and test the changes. Avoid making all your changes at
once as this can make testing more difficult.
With the default/factory settings:

SLNet is not configured

Connecting PCPro to the SL2100

Connection default IP Address:
172.16.0.10 / 255.255.0.0
You can check the IP address at any SL2100 system phone:
Press the centre Navigation Key and dial 841
Direct to Ethernet connector on the SL2100 CPU card.
Via the customer's LAN.
Quick Install Guide – SL2100 SLNet rev1.0
17