NEC SL2100 Quick Install Manual page 29

Configure the SL2100
At Node 1 use SLNet Remote Trunk Access – Trunk Group Routing for Extensions to define the trunk route
for each night mode that will be used for local extensions dialling the trunk access code.
Define the route to be used
for each night mode
At Node 1 use SLNet Remote Trunk Access – Trunk Group Routing to define the trunk group that will be
targeted by trunk route 2.
In our example the trunks are assigned to Trunk Group 3 so we enter group 3 for priority order 1.
Priority order2~4 are not required.
Define the trunk group(s)
At Node 1 use SLNet Remote Trunk Access – SLNet Incoming Trunk Access Route to define the route that
will be used by any inbound SLNet trunk access calls.
Define Route 2 for inbound trunk access
calls from Nodes 2 & 3.
Assign for all 8 night modes
Quick Install Guide – SL2100 SLNet rev1.0
29