Branson 2000 series Service Manual page 110

3. DISASSEMBLING AND SERVICING
< Rear wheel >
1. Place a jack under the transmission case.
2. Loosen the rear wheel bolt(1) and nut(2).
3. Take out the rear wheel.
◈ Important
When re-fitting or adjusting a wheel, tighten the
bolts to the following torques and then recheck
them after driving the tractor approximately
200m (200 yards).
Tightening Rear wheel
torque bolt and nut
< Rear axel case >
1. Remove the brake rod(1).
2. Disconnect the differential lock rod(2) at the
pedal side.
3. Remove the rear axle case mounting screws and
nuts then separate the rear axle case(3) from the
differential case.
▷ Reassembling
Apply gasket to joint face of the rear axle case
and differential gear case after removing the
water, oil and stuck gasket.
Tightening Rear axle case
torque mounting screw
108 to 125 Nm
*. PART NAME
11.0 to 12.7 kgfm
79 to 92.2 ft-lbs
48.1 to 55.8 Nm
*. PART NAME
4.9 to 5.7 kgfm
35.5 to 41.2 ft-lbs
108
(1)
(2)
1) Bolt
1) Brake rod
3) Rear axle case
REAR AXLE
2) Nut
2) Differential lock rod
KUKJE MACHINERY CO., LTD.