Advertisement
CMS440P2
DISCLAIMER
Milestone AV Technologies, and its affiliated corporations and
subsidiaries (collectively, "Milestone"), intend to make this
manual accurate and complete. However, Milestone makes no
claim that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Milestone
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Milestone assumes
no responsibility for accuracy, completeness or sufficiency of
the information contained in this document.
Chief® is a registered trademark of Milestone AV Technologies.
All rights reserved.
IMPORTANT SAFETY INSTRUCTIONS
WARNING
serious injury or death if you do not follow the instructions.
CAUTION
damage or destruction of equipment if you do not follow the
corresponding instructions.
WARNING
FOLLOW THE FOLLOWING INSTRUCTIONS CAN RESULT
IN SERIOUS PERSONAL INJURY, DAMAGE TO EQUIPMENT
OR VOIDING OF FACTORY WARRANTY. It is the installer's
responsibility to make sure all components are properly
assembled and installed using the instructions provided.
READ ALL INSTRUCTIONS BEFORE USING THIS
PRODUCT!!!!
DANGER:
ELECTRIC SHOCK:
1.
Always turn off power at source before installing the outlet.
WARNING:
BURNS, FIRE, ELECTRIC SHOCK, OR INJURY TO
PERSONS:
•
Always turn off power at source before servicing or
removing the outlet.
•
Use this mounting system only for its intended use as
described in these instructions. Do NOT use
attachments not recommended by the manufacturer.
•
Do not use outdoors - for indoor use only!
•
Route cables as shown in these installation
instructions.
•
To disconnect, turn off power at source.
2
alerts you to the possibility of
alerts you to the possibility of
:
FAILURE TO READ AND
TO REDUCE THE RISK OF
TO REDUCE THE RISK OF
WARNING
Make sure the outlet is properly grounded. See Grounding
Instructions.
WARNING
structural strength for this component can result in serious
personal injury or damage to equipment! It is the installer's
responsibility to make sure the structure to which this
component is attached can support five times the combined
weight of all equipment. Reinforce the structure as required
before installing the component.
WARNING
can result in serious personal injury or damage to equipment! It
is the installer's responsibility to make sure the combined
weight of all components attached to the CMS440P2 does not
exceed 50 lbs (22.68 kg).
•
The weight capacity of the CMS440P2 may be
LIMITED to the lowest weight capacity of any other
component located between the CMS440P2 and the
supporting structure!
CAUTION:
and assembled by qualified service personnel in accordance
with local building and electrical codes.
NOTE:
Knockouts are provided for ease of installation. Any
unused knockouts that have been punched are to be
closed up with a metal plug.
NOTE:
Ambient Temperature - The manufacturer's maximum
ambient temperature is 104°F (40°C) and minimum
ambient temperature is 30°F (-1°C) so that the installer
is able to determine acceptability of use of Accessories
and components.
CAUTION
:
Apparatus shall not be exposed to
dripping or splashing and no objects filled with liquids, such as
vases, shall be placed on the apparatus.
IMPORTANT ! :
The CMS440P2 is designed for installation
above existing suspended ceiling tile.
IMPORTANT ! :
The CMS440P2 has been designed to
support a single UL Listed electrical receptacle, a double UL
Listed electrical receptacle or both.
NOTE:
It is the installer's responsibility to ensure that the
enclosure is bonded to the ground in the switch box, in
accordance with the National Electric Code, ANSI/
NFPA 70 or Canadian Electrical Code, CSA C22.1.
--SAVE THESE INSTRUCTIONS--
Installation Instructions
:
RISK OF ELECTRIC SHOCK!
:
Failure to provide adequate
:
Exceeding the weight capacity
This equipment must be installed
Advertisement
