Angelcare AC701 Owner's Manual page 5

15.17 Object and Liquid Entry - NEVER
push objects of any kind into this product
through casing slots as they may touch
dangerous voltage points or short out
parts that could result in a risk of fire or
electric shock. NEVER spill liquid of any
kind on the product.
15.18 Antenna - The antenna used for this
transmitter must be installed to provide a
separation distance of at least 20 cm from
all persons and must not be collocated or
operating in conjunction with any other
antenna or transmitter.
15.19 Power Lines - An outside antenna
system should NOT be located in the
vicinity of overhead power lines or other
electric light or power circuit, or where it
can fall into such power lines or circuits as
contact with them may be fatal.
15.20 WARNING Strangulation Hazard —
Children have STRANGLED in cords. Keep
adapter cords out of the reach of children
Sensor Pad(s) if protective covering is
damaged or broken.
15.21 Interference - This monitor uses
public air waves to transmit signals .
The Parent Unit may pick up signals or
interference from other nursery monitors
in your area. Your monitor may even be
picked up by other households. To protect
your privacy, make sure both units are
turned OFF when not in use.
15.22 Vibration Source - When the monitor
is in use, DO NOT use a crib mobile or
other crib accessories that may produce
vibrations. Other sources of vibrations
may include fans, washing machines, loud
music, etc. These sources of vibration may
interfere with the performance of your
Angelcare ® monitor and the alarm will
not sound if it continues to detect any
movement other than your baby's. Be sure
all vibration sources are eliminated before
using the monitor.
(more than 1 m away).
NEVER use Sensor
Pad(s) without the
p r o t e c t i v e c o r d
c o v e r i n g . C h e c k
p r o t e c t i v e c o r d
covering before each
u s e . I m m e d i a t e l y
discontinue use of
You may experience false alarms for several
reasons. The most common reason is the
Nursery Unit has not been turned OFF after
you have removed your baby from the crib.
Another reason is the Sensor Pad has not
been placed under the mattress properly.
Be sure the Sensor Pad is on a flat, firm
surface with the printed side facing up.
The sensitivity level may also need to be
adjusted. Refer to Step 5.1. Always be sure
to immediately check on baby whenever
an alarm sounds.
15.23 Sensor Pad - If the crib has a
spring or slat base, place a hard board
between the crib base and the Sensor Pad
measuring at least 33 x 33 cm and 6 mm
thick. Only use your Angelcare
in a stationary sleeping environment such
as a crib where the Sensor Pad can rest
on a completely flat, firm surface. ALWAYS
route the Sensor Pad cord below crib
mattress and out of reach of children.
The sensor pad is made of plastic and does
not permit the air to circulate. Therefore,
mildew build up could develop underneath
the mattress in the sensor pad area. We
suggest rotating the mattress regularly to
prevent any mildew.
E
N
monitor
®
5