Table of Contents
Advertisement
FUNCTION INTRODUCTION
There are two ways of initiating scan:
●
Main Channel Scan( Manual): Your radio scans all the channels/groups in your scan list. On
entering scan, your radio may depending on the settings, automatically start on the last scanned "
active" channel/group or on the channel where scan was initiated.
●
Auto Scan ( Automatic): Your radio automatically starts scanning when you select a channel/group
that has Auto Scan enabled.
2.Starting and stopping Scan
1.
Press the scan key, or turn channel knob to select an automatic activity channel.
2.
The LED blinks orange when Scan is enabled, you can hear a confirm sound.
Or the LED turns off when Scan is disabled, you will hear an unconfirmed sound.
3.Priority Scan
When radio set with the priority channels, it allows to enable the priority scan function, the priority
scan mode is cycle scan method, it will scan the priority channel each time after scan a common
channel.
4.Responding to a call during scan
During scan, your radio stay at activity channel/communication group.
The radio stays on that channel for a time period knows as "hang time".
1.
Hold the radio vertically 1 to 2 inches (2.5 to 5.0 cm) from your mouth. If the channel Free
Indication feature is enabled, you will hear a short alert tone the moment the target radio release
the [PTT] key, indicating the channel is free for you to respond.
2.
Press [PTT] key during hang time, red LED turns on.
22
Professional
FM Transceiver
Advertisement
Table of Contents
