Setting The Fence - Axminster AC1950B Original Instructions Manual

Fig 37
3) Check that the blade is perpendicular to the table. If it is not,
try resetting the table by loosening the lift & shift handles and
adjusting the table stop nut until perpendicularity is achieved,
see fig 37.
4) Move the square up against the back of the blade and
check it's square against the table, see fig 38. If adjustment is
required loosen the locking handles, pivot the table and lock
in place. Loosen the bolts holding the tilt quadrant, using a
Hex key adjust the four grub screws in the quadrant. For model
AC1950B, adjust the grub screws beneath the mounting plate,
see fig 39-40. Make small adjustments, lower the table and
postion the square as before. Continue until the blade is square
to the table. Tighten the tables bolts to secure in place. Note:
check the blade is still square against the table as shown in
fig 36 and make adjustments to the table stop if required.
Fig 38-39-40
Model AC2305B, AC2606B
Mounting plate
Grub screws
Model AC1950B
Grub screws
Hex key
5) Lower the table down and check that the pointer of the tilt
scale reads zero, if not, loosen the Phillips screw and reposition
the pointer, see fig 41.
Pointer

Setting the Fence

1) Line up the fence (4) with the edge of the tables 'T' slot and
press down the locking handle., see fig 42. If the fence is out of
alignment, loosen the two Hex screws either side of the fence
clamping assembly. Adjust the fence until its in alignment with
the 'T' slot, retighten the Hex screws, see fig 43.
19
Setting Up the Saw
Fig 42
'T' Slot
Continues over...
Fig 41