Table of Contents
Advertisement
2
Installation
2.1
Installing the Controller
Install the controller in an indoor, dry, clean,
accessible location. If using the optional pipe
temperature sensor, make sure you install the
controller within 328 ft (100 m) of where you want to
monitor the pipe temperature.
Opening the controller
WARNING: To prevent shock, always switch off
the power supply (circuit breaker) before opening the
controller.
The HWAT-ECO has a removable front cover. Both
the cover and the box have electronic parts and are
connected to each other by a 14-pin connector. First
unscrew the four screws in the cover. Carefully pull
the cover straight out, not sideways!
nVent.com | 9
Raychem-IM-H57340-HWATECOcontroller-EN-1805
Hide quick links:
Advertisement
Table of Contents
