Switching The Input Mode; Adjusting The Volume; Displaying The Black Screen And Turning Off The Sound Temporarily - Sharp Notevision PG-D45X3D Operation Manual

Select the appropriate Input mode for the
connected equipment.
Press
on the remote control to select
the Input mode.
• When you press INPUT on the projector or DVI
on the remote control, the INPUT list appears.
Press P/R to switch the Input mode.
Press / on the remote control
or O/Q on the projector to adjust
the volume.
Note
• Pressing VOL–/–O will lower the volume.
• Pressing VOL+/Q+ will raise the volume.
• When the projector is connected to external
equipment, the volume level of the external
equipment changes in accordance with the
volume level of the projector. Set the projector's
volume to the lowest level when turning the
projector on/off or when changing the input signal.
• When you do not want to output the sound
from the projector's speaker while the
projector is connected to external equipment,
set "Speaker" in "PRJ-ADJ" menu to "Off".
(See page 46.)
Press on the remote control
or close the lens shutter to temporarily
display a black screen and turn off the
sound.
Note
• Pressing AV MUTE again will turn the
projected image back on.
• When you close the lens shutter, the projector will
be AV Mute mode and then the projector will be
turned off automatically after about 30 minutes.
, , or
On-screen display On-screen display
On-screen display On-screen display
COMPUTER, DVI, COMPUTER, DVI,
S-VIDEO, VIDEO S-VIDEO, VIDEO
buttons buttons
AV MUTE button AV MUTE button
VOL +/– (Volume) VOL +/– (Volume)
buttons buttons
29