Turning The Projector On/Off; Connecting The Power Cord; Turning The Projector On; Turning The Power Off (Putting The Projector Into Standby Mode) - Sharp Notevision XG-C435X-L Operation Manual

Turning the Projector On/Off

Connecting the Power Cord

Plug the supplied power cord into the AC
socket on the rear of the projector. Then plug
into the AC outlet.

Turning the Projector On

Before performing the steps in this section,
connect any equipment that you use with the
projector. (See pages 23-29.)
Remove the lens cap and press
STANDBY/ON on the projector or ON
on the remote control.
• The power indicator illuminates green.
• After the lamp indicator illuminates, the projec-
tor is ready to start operation.
Note
• The lamp indicator illuminates or blinks, in-
dicating the status of the lamp.
Green: The lamp is on.
Blinking green: The lamp is warming up.
Red: The lamp is shut down abnor-
mally or the lamp should be
replaced.
• When switching on the projector, a slight flicker-
ing of the image may be experienced within the
first minute after the lamp has been illuminated.
This is normal operation as the lamp's control
circuitry is stabilizing the lamp output charac-
teristics. This does not indicate malfunction.
• If the projector is put into standby mode and
immediately turned on again, the lamp may
take some time to illuminate.
• When System Lock is set, the keycode in-
put box appears. To cancel the keycode set-
ting, input the keycode that you have already
set. See page 52 for details.
Turning the Power Off
ting the Projector into Standby Mode)
Press STANDBY/ON on the projector or
STANDBY on the remote control, then press
that button again while the confirmation mes-
sage is displayed, to put the projector into
standby mode.
-30
Supplied
accessory
Info
• When "Auto Restart" is set to "On":
If the power cord is unplugged from the outlet or the
breaker switch is turned off when the projector is on, then
the projector automatically turns on when the power cord
is plugged into the AC outlet or the breaker switch is turned
on. (See page 51.)
• English is the factory preset language. If you want to
change the on-screen display to another language, change
the language according to the procedure on page 50.
STANDBY/ON button
ON button
STANDBY
button
▼On-screen Display
(Put-
Info
• Direct Power Off function:
You can unplug the power cord from the AC outlet
even if the cooling fan is still running.
AC socket
Power indicator
Power cord
To AC outlet
Lamp
indicator