Selecting The Dynamic Range; Setting The Video System; Checking The Input Signal - Sharp Notevision XG-C435X-L Operation Manual

Signal Adjustment ("SIG-ADJ" Menu)
5 5

5 Selecting the Dynamic Range

5 5
An optimum picture may not be displayed if a
DVI-D-capable device's output signal type and the
projector's input signal type do not match. If this
should occur, switch "Dynamic Range".
Selectable items
Auto When the black levels of the image show
Standard banding or appear faded, select the item
Enhanced that results in the best picture quality. (In
most circumstances, "Standard" should
be selected.)
Note
• The Dynamic Range can be selected only when
"DVI-D" input mode is selected.
6

6 Setting the Video System

6
6 6
The video input system mode is factory preset
to "Auto"; however, a clear picture from the con-
nected audio-visual equipment may not be re-
ceived, depending on the Video signal difference.
In that case, switch the Video signal.
Selectable items
Auto
PAL
SECAM
*NTSC4.43
NTSC3.58
PAL-M
PAL-N
PAL -60
* When reproducing NTSC signals in PAL video
equipment.
Note
• The Video signal can only be set in VIDEO or
S-VIDEO mode.
• When "Video System" is set to "Auto", you may
not receive a clear picture due to signal differ-
ences. Should this occur, switch to the video
system of the source signal.
-48
Description
Menu operation

7 Checking the Input Signal

7 7
7 7
This function allows you to check the current in-
put signal information.
Page 43