Signal Adjustment ("Sig-Adj" Menu); Adjusting The Computer Image; Resolution Setting; Auto Sync Adjustment - Sharp Notevision XG-C435X-L Operation Manual

Signal Adjustment ("SIG-ADJ" Menu)

SIG – ADJ
Pict.
Clock
Phase
1
H-Pos
V-Pos
Reset
2
Resolution
3
Auto Sync
4
Signal Type
5
Dynamic Range
6
Video System
Signal Info : 800 x 600
7
H 60.3 kHz / V
SEL./ADJ.
RETURN
1 1

1 Adjusting the Computer Image

1 1
If the optimum image cannot be obtained with Auto
Sync adjustment, use the SIG-ADJ function.
Selectable items
Clock Adjusts vertical noise.
Phase Adjusts horizontal noise (similar to
tracking on your VCR).
H-Pos Centers the on-screen image by
moving it to the left or right.
V-Pos Centers the on-screen image by
moving it up or down.
Note
• To reset all adjustment items, select "Reset" and
press ENTER.
• The adjustable range of "H-Pos" (H-Position)
and "V-Pos" (V-Position) may vary depending
on the screen resolution of the computer.
2

2 Resolution Setting

2
2 2
Ordinarily, the type of input signal is detected and the
correct resolution mode is automatically selected. How-
ever, for some signals, the optimal resolution mode in
"Resolution" on the "SIG-ADJ" menu may need to be
selected to match the computer display mode.
Note
• See "Checking the Input Signal" on page
information on the currently selected input sig-
nal.
SCR PRJ Net.
0
0
0
0
640 x 480
On
Auto
Standard
Auto
37.8 Hz
ENTER
END
Description
48 for
Menu operation

3 Auto Sync Adjustment

3 3
3 3
Used to automatically adjust a computer image.
Selectable items
On Auto Sync adjustment will occur when
the projector is turned on or when the
input signals are switched, when
connected to a computer.
Off Auto Sync adjustment is not automati-
cally performed.
Note
• Auto Sync adjustment is also performed by
pressing AUTO SYNC on the projector or on
the remote control.
• The Auto Sync adjustment may take some time
to complete, depending on the image of the
computer connected to the projector.

4 Signal Type Setting

4 4
4 4
This function allows you to select the input sig-
nal type RGB or Component for COMPUTER/
COMPONENT 1, 2 or DVI-D.
Selectable items
Auto Input signals are automatically recog-
nized as RGB or component.
RGB Set when RGB signals are received.
Component Set when Component signals are
received.
Page 43
Description
Description
-47