Turning The Projector On/Off; Connecting The Power Cord; Turning The Projector On; Turning The Power Off (Putting The Projector Into Standby Mode) - Sharp Notevision XG-C335X Operation Manual

Turning the Projector On/Off

Connecting the Power Cord

Plug the supplied power cord into the AC
socket on the rear of the projector. Then plug
into the AC outlet.

Turning the Projector On

Before performing the steps in this section,
connect any equipment that you use with the
projector. (See pages 23-29.)
Remove the lens cap and press
STANDBY/ON on the projector or
ON on the remote control.
• The power indicator illuminates green.
• After the lamp indicator illuminates, the projec-
tor is ready to start operation.
• When System Lock is set, the keycode input
screen appears. Enter the right keycode to
start projection. See page
Note
• The lamp indicator illuminates or blinks, in-
dicating the status of the lamp.
Green: The lamp is on.
Blinking green: The lamp is warming up.
Red: The lamp is shut down abnor-
mally or the lamp should be
replaced.
• When switching on the projector, a slight flicker-
ing of the image may be experienced within the
first minute after the lamp has been illuminated.
This is normal operation as the lamp's control
circuitry is stabilizing the lamp output charac-
teristics. This does not indicate malfunction.
• If the projector is put into standby mode and
immediately turned on again, the lamp may
take some time to illuminate.
Turning the Power Off
ting the Projector into Standby Mode)
1
Press STANDBY/ON on the
projector or
remote control, then press that
button again while the confirma-
tion message is displayed, to put
the projector into standby mode.
-30
49 for details.
(Put-
STANDBY on the
Supplied
accessory
AC socket
Info
• If "Direct Power On" is set to "Enable", the projector
will be turned on automatically when you plug the
power cord into the AC outlet. (See page 50.)
• English is the factory preset language. If you want to
change the on-screen display to another language,
change the language according to the procedure on
page 54.
Power indicator
STANDBY/ON button
ON button
STANDBY
button
▼On-screen Display
Info
• You can unplug the power cord even if the projector is
operating.
• Even if you unplug the power cord from the projector, the
cooling fan continues to run for a while.
Power cord
To AC outlet
Lamp
indicator