Controlling The Projector By A Computer - Sharp Notevision XG-C335X Operation Manual

Controlling the Projector by a Computer

When the RS-232C terminal on the projector is connected to a computer, the computer can be used to control
the projector and check the status of the projector. Refer to the "SETUP MANUAL" contained on the supplied
CD-ROM for "RS-232C Specifications and Commands".
When connecting to a computer using an RS-232C serial control cable and a DIN-D-sub RS-232C adaptor
Computer
To RS-232C terminal
RS-232C serial control cable (cross type, commercially available)
Note
• The RS-232C function may not operate if your computer terminal is not correctly set up. Refer to the
operation manual of the computer for details.
Info
• Do not connect the RS-232C cable to a port other than the RS-232C terminal on the computer. This may
damage your computer or projector.
• Do not connect or disconnect an RS-232C serial control cable to or from the computer while it is on. This
may damage your computer.
Supplied
accessory
To RS-232C terminal
DIN-D-sub
RS-232C adaptor
DIN-D-sub
RS232C adaptor
-27