Computer Image Adjustment ("Fine Sync" Menu); Adjusting The Computer Image; Resolution Setting; Auto Sync Adjustment - Sharp Notevision XG-C335X Operation Manual

Computer Image Adjustment ("Fine Sync" menu)

Fine Sync

Clock
Phase
1
H-Pos
V-Pos
Reset
2
Resolution
3
Auto Sync
Signal Info
4
SEL./ADJ.
RETURN
1

1 Adjusting the Computer Image

1
1 1
If the optimum image cannot be obtained with Auto
Sync adjustment, use the Fine Sync function.
Selectable items
Clock Adjusts vertical noise.
Phase Adjusts horizontal noise (similar to
tracking on your VCR).
H-Pos Centers the on-screen image by
moving it to the left or right.
V-Pos Centers the on-screen image by
moving it up or down.
Note
• To reset all adjustment items, select "Reset" and
press ENTER.
• The adjustable range of "V-Pos" (V-Position) may
vary depending on the screen resolution of the
computer.

2 Resolution Setting

2 2 2 2
Ordinarily, the type of input signal is detected and the
correct resolution mode is automatically selected. How-
ever, for some signals, the optimal resolution mode in
"Resolution" on the "Fine Sync" menu may need to be
selected to match the computer display mode.
Note
• If your computer displays patterns which repeat
every other line (horizontal stripes), flickering
may occur which makes the image hard to see.
• See "Checking the Input Signal" on the right
column for information on the currently selected
input signal.
-46
COMP.1
0
0
0
0
640 × 480
On
ENTER
END
Description

3 Auto Sync Adjustment

3 3
3 3
Used to automatically adjust a computer image.
Selectable items
On Auto Sync adjustment will occur when
the projector is turned on or when the
input signals are switched, when
connected to a computer.
Off Auto Sync adjustment is not automati-
cally performed.
Note
• Auto Sync adjustment is also performed by
pressing AUTO SYNC on the projector or
AUTO SYNC on the remote control.
• The Auto Sync adjustment may take some time
to complete, depending on the image of the
computer connected to the projector.

4 Checking the Input Signal

4 4
4 4
This function allows you to check the current in-
put signal information.
Menu operation Page
Description
42