Table of Contents
Advertisement
drops after each hour of continual
use.
2.
Attach an air hose to the
compressor's air outlet. Connect the
air hose to the air inlet of the tool.
Other components, such as a coupler
plug and quick coupler, will make
operation more efficient, but are not
required.
warning! tO preVent SeriOuS
injurY frOm accidental
OperatiOn:
do not install a female quick
coupler on the tool. Such a coupler
contains an air valve that will allow
the air tool to retain pressure and
operate accidentally after the air
supply is disconnected.
note: Air flow, and therefore tool
performance, can be hindered by
undersized air supply components.
3.
The air hose must be long enough
to reach the work area with enough
extra length to allow free movement
while working.
4.
Turn the tool's throttle or switch to the
off position; refer to Operation section
for description of controls.
5.
Close the in-line safety valve between
the compressor and the tool.
6.
Turn on the air compressor according
to the manufacturer's directions and
allow it to build up pressure until it
cycles off.
7.
Adjust the air compressor's output
regulator so that the air output is
enough to properly power the tool,
but the output will not exceed the
tool's maximum air pressure at any
time. Adjust the pressure gradually,
Page 8
for technical questions, please call 1-800-444-3353.
while checking the air output gauge
to set the right pressure range.
8.
Inspect the air connections for leaks.
Repair any leaks found.
9.
If the tool will not be used at this
time, turn off and detach the air
supply, safely discharge any
residual air pressure, and release
the throttle and/or turn the switch to
its off position to prevent accidental
operation.
note: Residual air pressure should not be
present after the tool is disconnected
from the air supply. However, it is a
good safety measure to attempt to
discharge the tool in a safe fashion
after disconnecting to ensure that the
tool is disconnected and unpowered.
inStructiOnS fOr
putting intO uSe
read the entire impOrtant
SafetY infOrmatiOn
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
inspect tool before use, looking
for damaged, loose or missing
parts. if any problems are
found, do not use tool until
repaired.
SKU 67473
Advertisement
Table of Contents
