Table of Contents
Advertisement
20.
Do not fire the Rivets too close to the edge of a workpiece. They may split the
workpiece and cause it to fly free, causing personal injury.
21.
Transport the Riveter safely. Always disconnect the air supply when moving the
tool in the workplace. Carry the tool by the handle and avoid contact with the Trigger
(40).
22.
Avoid working alone. If an accident happens, an assistant can bring help.
23.
Always attach the Safety Cap (23) to the Riveter prior to using the tool. Make
sure the slot in the Safety Cap faces upward to avoid spilling used Rivet Pins.
24.
WARNING! Some dust created by power sanding, sawing, grinding, drilling,
and other construction activities contain chemicals known (to the State of California)
to cause cancer, birth defects, or other reproductive harm.
Some examples of these chemicals are:
* Lead from lead-based paints,
* Crystalline silica from bricks, cement, and other masonry products,
* Arsenic and chromium from chemically treated lumber.
(California Health & Safety Code § 25249.5, et seq. )
25.
WARNING! The warnings, cautions, and instructions discussed in this instruction
manual cannot cover all possible conditions and situations that may occur. It must
be understood by the operator that common sense and caution are factors which
cannot be built into this product, but must be supplied by the operator.
1.
For best service, you should incorporate an oiler, regulator, and inline filter, as shown
in the diagram below. Hoses, couplers, oilers, regulators, and filters are all available
at Harbor Freight Tools. NOTE: If an automatic oiler is not used, put 3-5 drops of
pneumatic Tool Oil (not included) in the tool's quick connector before each use.
(See Figure A.)
FIGURE A
SKU 167
For technical questions, please call 1-800-444-3353
ASSEMBLY INSTRUCTIONS
REGULATOR
FILTER
OILER
PAGE 4
Hide quick links:
Advertisement
Table of Contents
