VWR peqlab PCR Workstation Pro Instruction Manual page 9

Instruction Manual PCR Workstation Pro
Assemble the back panel 2 onto the base
1. The connecting link of the base 1 must
fit in the back panel 2. Pay attention not
to squeeze the sensor cable.
Connect both parts by screwing 3 screws 8 into the back side. Use the screw driver 9 to do this.
Turn the parts around 90° on the site of operation and incline both screwed parts to the back part
of the back panel 2. Screw both panels with 2 screws 8 from underneath. Tilt back the panels in
starting position with the back panel facing backwards.
Step 2
Back panel 2
Remove the protective foil from the side
panels.
Side panel 3
Insert the side panels 3 into the guiding rails
at the base 1 and push up against the back
panel 2 within the guiding rails at both
sides. Carefully screw the side panels 3 with
3 screws each in the base 1 and the back
panel 2, respectively. Use the supplied
screws 8 and the screwdriver 9.
Side panel 3
Base 1
PEQLAB_v0517_E 7