Table of Contents
Advertisement
Initial S110 setup
The WW100 is configured with a Sinamics S110 CU305DP control and power module.
1.
Ensure the electrical connections match the connection diagrams in the Appendix.
2.
Apply power to the power module and allow boot sequence to run. The steady
green LED next to RDY on the unit indicates that the boot sequence is complete.
Notes:
•
Do not continue until the boot sequence is complete.
•
If the drive is in alarm state, refer to the S110 user manuals and/or contact your
Siemens representative.
3.
Remove the power and ensure all power sources to the drive are switched OFF.
4.
Insert the pre-programmed Micro Memory Card (MMC) into the slot below the S110
display and ensure the card locks into place.
5.
Apply main AC power and then 24 Volt DC power to the device and allow the
application software to load.
Do not use P977 until software has loaded and parameters have
been set.
Failure to allow the software to load completely can result in lost
and irretrievable software and application data.
1
6.
The S110 display will show "0.0" in the parameter/value field (2) when the software is
finished loading and fault F01650 has been acknowledged
Notes:
•
Do not continue until the software is loaded.
•
To acknowledge fault, press
S110 user manuals and/or contact your Siemens representative).
7.
Test the functionality of drive
a.If belt is travelling in reverse, set P1113 to either "0" or "1" (see
direction on page 10
8.
Set the maximum RPM P2000 (see
9.
Verify RPM output on display.
7ML19985MN01
SITRANS WW100 - OPERATING INSTRUCTIONS
2
3
4
key (3) on display. (For more fault codes, see the
).
P2000 - Maximum RPM on page 11
S110 Display
1.Drive number: there are two drive
data sets, each with their own set of
parameters.
01 = Command Data Set
02 = Drive Data Set
2.Parameter/value
RUN mode
EDIT mode
3.Function key
4.Parameter key
.
P1113 - Belt
).
Page 9
Advertisement
Table of Contents
