Operating Instructions - Central Pneumatic 98189 Set Up And Operating Instructions Manual

7. Adjust the air compressor's output
regulator so that the air output is
enough to properly power the tool,
but the output will not exceed the
tool's maximum air pressure (90
PSI), at any time. Adjust the pres-
sure gradually, while checking the air
output gauge to set the right pressure
range.
8. Inspect the air connections for leaks.
Repair any leaks found.
9. If the tool will not be used at this
time, turn off and detach the air sup-
ply, safely discharge any residual air
pressure, and release the throttle
and/or turn the switch to its off posi-
tion to prevent accidental operation.
note: Residual air pressure should not be
present after the tool is disconnected
from the air supply. However, it is a
good safety measure to attempt to
discharge the tool in a safe fashion
after disconnecting to ensure that all
excess air has been discharged.

operAting instructions

read the entire iMportAnt
sAFetY inForMAtion
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
inspect tool before use, looking
for damaged, loose, and
missing parts. if any problems
are found, do not use tool until
repaired.
1. Use hook and loop sand paper (not
supplied) for this Air Reciprocating
Sander. Large sheets can be eas-
SKU 98189 For technical questions, please call 1-800-444-3353.
ily cut to size. The correct size sand
paper is 2-7/16" L X 3/4" W
2. The recommended air hose for this
Air Reciprocating Sander is at least
3/8" (delivering no more than maxi-
mum of 90° PSI). The air inlet size is
1/4"-18 NPT.
3. Connect an air compressor to an air
pressure regulator and set the air
pressure to 90 PSI.
4. Apply sand paper (not supplied) to
the Plate (34). Cut the sand paper to
size if necessary.
5. Secure all workpieces with a clamp
or vise so pressure will not cause the
workpiece to shift its position. Use
the Air Reciprocating Sander with one
hand only. Keep your free hand clear
of the sanding operation.
6. Connect the Air Reciprocating Sander
to the air compressor hose at Air
Regulator Assembly (30).
7. Grip the Handle (35) with one hand,
depress the Air Valve Lever (28) and
the oscillation will begin. The speed
of the oscillation can be controlled by
turning the Air Regulator Knob (36).
The closer the dial is to "MAX", the
faster the oscillation will be.
8. Allow the motor to reach its full speed
before starting to sand.
9. Always keep a safe distance from
the Sanding Plate (34) while the Air
Reciprocating Sander is operating.
Do not apply excess pressure. If the
Sanding Plate (34) slows down while
you are sanding, you are applying too
much pressure. Allow the Air Recip-
rocating Sander to do the job.
Page 9