Power Connector Cable - HP ProBook x360 440 G1 Maintenance And Service Manual

Power connector cable

Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Place the computer in "Battery Safe mode"
3. Disconnect all external devices connected to the computer.
4. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
5. Remove the following components:
a. Service door
b. Keyboard
c. Top cover
d. Battery
e. Display assembly
Remove the power connector cable:
1. Disconnect the cable from the system board (1).
2. Lift the cable side of the connector upward (2), and the pull the connector (3) out from under the tab (4)
to remove it .
Reverse this procedure to install the power connector cable.
(Service doors on page
(Keyboard on page 40)
(Top cover on page 47)
(Battery on page 52)
Display assembly on page
(Battery Safe mode on page
32).
62)
Component replacement procedures
Spare part number
L28264-001
31).
79