Display Assembly - HP ProBook x360 440 G1 Maintenance And Service Manual

Display assembly

NOTE: Displays are spared only at the subcomponent level.
Before disassembling the display assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Place the computer in "Battery Safe mode"
3. Disconnect all external devices connected to the computer.
4. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
5. Remove the following components:
a. Service door
b. Keyboard
c. Top cover
d. Battery
Remove and disassemble the display assembly:
1. Remove the six Torx T8 2.5×6.0 screws (1) that secure the display assembly to the computer.
2. Disconnect the display cables from the system board (2).
3. Close the display assembly partially, to about 30 degrees (1).
62 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
(Service doors on page
(Keyboard on page 40)
(Top cover on page 47)
(Battery on page 52)
(Battery Safe mode on page
32).
31).