Fingerprint Reader Assembly - HP ProBook x360 440 G1 Maintenance And Service Manual

Fingerprint reader assembly

Description
Fingerprint reader assembly
Fingerprint reader bracket (included in Bracket Kit)
Fingerprint reader insert (included in Plastics Kit; for use in models without a fingerprint reader)
Before removing the fingerprint reader assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Place the computer in "Battery Safe mode"
3. Disconnect all external devices connected to the computer.
4. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
5. Remove the following components:
a. Service door
b. Keyboard
c. Top cover
Remove the fingerprint reader assembly:
1. Position the top cover upside-down.
2. Slide the bracket toward the side of the top cover, and then lift it off the fingerprint reader board (1).
TIP:
50 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
(Service doors on page
(Keyboard on page
(Top cover on page
A tool may be required to push and disengage the bracket.
(Battery Safe mode on page
32).
40)
47)
Spare part number
L28254-001
L29057-001
L29889-001
31).