Shutting Down The Ups; Operation On Battery Power; Return Of Ac Input Power; Ups Remote Control Functions - IBM 5595-1AX Installation And User Manual

Shutting down the UPS

About this task
To shut down the UPS:
Procedure
Press the
The UPS starts to beep and shows a status of "UPS shutting OFF...". The UPS
then transfers to Standby mode, and the

Operation on battery power

Transfer to battery power
v The connected devices continue to be supplied by the UPS when AC input
v The
v The audio alarm beeps every ten seconds.
Note: The connected devices are supplied by the battery pack.
Low-battery warning
v The
v The audio alarm beeps every three seconds.
Note: The remaining battery power is low. Shut down all applications on the
connected equipment because automatic UPS shutdown is imminent.
End of battery backup time
v LCD displays "End of backup time".
v All the LEDs go OFF.
v The audio alarm stops.
v The UPS shuts down.

Return of AC input power

Following an outage, the UPS restarts automatically when AC input power returns
(unless the restart function has been disabled) and the load is supplied again.

UPS remote control functions

The IBM UPS offers a choice between two remote control functions.
24
Installation and User's Guide
button on the UPS front panel for three seconds.
power is no longer available. The necessary energy is provided by the battery
packs.
and indicator illuminates solid.
and indicator illuminates solid.
Remote Power Off (RPO): allows a remote contact to be used to disconnect all
the equipment connected to the UPS. Restarting the UPS requires manual
intervention.
Remote ON/OFF (ROO): allows remote action of the
the UPS.
indicator turns off.
button to shut down