Display Functions - IBM 5595-1AX Installation And User Manual

Display functions

Press the Enter (
buttons (
button to select an option. Press the
menu.
10
Installation and User's Guide
Operation status
End of backup time
1 beep every 3 seconds
) button to activate the menu options. Use the two middle
and ) to scroll through the menu structure. Press the Enter (
Main menu Submenu
Measurements
Control Load Segments
Start battery test
Reset fault state
Restore factory settings
Reset power usage
Settings Local settings
Input/output settings
On/Off settings
Battery settings
Fault log
Identification
Cause
The UPS is on Battery mode
and the battery packs are
running low.
button to cancel or return to the previous
Display information or Menu function
Load W VA / Load A pf / Output V Hz
/ Input V Hz / Battery V min /
Efficiency / Power usage
Outlet Group 1: ON / OFF
Outlet Group 2: ON / OFF
These commands overrule user settings
for load segments.
Starts a manual battery test
Clears active fault (UPS restart required)
Returns all settings to original values
Clears power usage measurements
Sets product general parameters
Sets input and output parameters
Sets On/Off conditions
Sets battery configuration
Displays event log or alarms
UPS Type / Part Number / Serial
Number / Firmware release / Com. card
address
Description
This warning is approximate,
and the actual time to shut
down might vary
significantly.
Depending on the UPS load,
the "Battery Low" warning
might occur before the
battery packs reach 20 %
capacity.
)