Sharp DX-AT50 Operation Manual page 49

To check the timer setting:
1 While in the timer playback stand-by mode,
press the TIMER button.
2 Within 10 seconds, press the or
the ENTER button.
The system returns to the timer playback stand-by mode after the setting con-
tents are displayed in order.
When the start time is reached:
Playback starts automatically and the volume increases gradually.
The timer playback indicator flashes.
Timer play indicator
When the finish time is reached:
The system is set to the power stand-by mode automatically.
button to select "TIMER CALL", and press
Timer set Indicator
Reusing the memorized timer setting:
The timer setting will be memorized once it is entered. To reuse the same setting,
perform the following operations.
1 Turn the power on and press the TIMER button.
Set the AV control unit on time if "TIMER STANDBY" does not appear.
2 Within 10 seconds, press the ENTER button.
After the setting contents are displayed in order, the system is set to the timer play-
back stand-by mode.
Changing the timer setting:
Turn the power on, and repeat the operation from step 1 in "Setting the timer" (page
43).
Canceling the timer playback:
Timer playback is canceled by turning the power on while in the timer playback
stand-by mode. The same operation can be performed in the following procedure
without turning the power on.
1 Press the TIMER button.
"TIMER CANCEL" will appear.
2 Within 10 seconds, press the ENTER button.
Timer playback will be canceled (the contents of the setting will not be canceled).
Caution:
! The contents of the setting will be erased if the system is unplugged or a power
failure occurs. In such cases, set the timer again.
! This system cannot set the timer of other equipment.
! When setting the timer playback using the digital tuner, TV, VCR, or the connected
equipment should be set to timer playback at the same time.
Note:
The timer operation is disabled with discs containing menus.
SD-AT50
DX-AT50
ENGLISH
E-44