Table of Contents
Advertisement
DPC 8000
LED
POWER
FAULT
ALARM
Depending on the current status of the system, the illuminated LC display with 122 x 32 pixels
shows time information, operating states, user information, setup information, error messages
with precise device/module descriptions, and so on.
Status display in the LC display
During normal operation in announcement mode, the name of the call station (line 1) and the
date and time (line 2) are displayed in the LC display.
Error display in the LC display
If an error occurs in the PROMATRIX 8000 system, this is displayed on the call station as
follows:
•
•
•
•
The error display and signal tone must be configured via the configuration in IRIS-Net.
8.2
Functions
After being switched on, the call station will be in announcement mode. The menu mode is
used to configure the call station.
Status
Green, flashing quickly
Off
Illuminated green
Off
Illuminated yellow
Flashing yellow
Off
Illuminated red
Flashing red
The FAULT LED flashes, and a signal tone is sounded via the built-in loudspeaker
The error is displayed in the LC display
Pressing the ESC button confirms the error message, and deactivates the signal tone. At
the same time, the FAULT LED switches from flashing to permanently illuminated. If a
new error occurs, confirmation is required once again
The FAULT LED signals an error in the PROMATRIX 8000 system for as long as it exists
Description
•
At least one of the selected circuits is
occupied with higher priority
(announcement, gong, alarm) and
cannot be interrupted
•
A call that has already started will be
interrupted by the higher priority
The call station power supply has been
deactivated/interrupted
The call station power supply is functioning
correctly
System is running smoothly
There is an error in the PROMATRIX 8000
system – details are displayed in the LC
display
There is a new, as yet unconfirmed error in
the PROMATRIX 8000 system – details are
displayed in the LC display
No alarm started
The alarm was triggered by any station
The alarm has already been stopped, but is
running until the end of the signal
Operation | en
25
28-Feb-2013 | |
Advertisement
Table of Contents
