Dynacord DPC 8000 Manual page 23

DPC 8000 Configuration | en 23
CAN address
Pressing the ↵ button takes the user to the CAN Address dialog box. Pressing the ↑ or ↓
button sets the required CAN address. The call station can be assigned a CAN address
between 1 and 16.
Pressing the ↵ button accepts the address selected, and returns the user to the Setup menu.
Warning!
!
By default, all call stations have the address OFF (no address). First of all, a valid address
must be entered. Only one call station address may be used for each DPM 8016!
CAN baud rate
Pressing the ↵ button takes the user to the CAN Baud Rate dialog box. Pressing the ↑ or ↓
button toggles between the available baud rates. Pressing the ↵ button accepts the setting
selected, and returns the user to the Setup menu.
CAN termination
Pressing the ↵ button takes the user to the CAN Termination dialog box. Pressing the ↑ or ↓
button activates or deactivates the termination on this call station. Termination must be
activated on the call station that is connected to the end of the CAN bus. Please see section
CAN bus basics, page 34.
Pressing the ↵ button accepts the setting selected, and returns the user to the Setup menu.
Firmware version
Displays the version of the call station firmware.
Monitor vol.
Pressing the ↵ button takes the user to the Monitor Vol dialog box. Pressing the ↑ or ↓ button
adjusts the volume level of the loudspeaker.
Pressing the ↵ button accepts the setting selected, and returns the user to the Setup menu.
28-Feb-2013 | |