Table of Contents
Advertisement
DPC 8000
7
Configuration
The call stations of a PROMATRIX 8000 system should be configured on the control panel via a
PC using IRIS-Net as this is the simplest method, and there are no restrictions. Only limited
programming is possible on the actual call stations themselves. To configure the call station
via the LC display, the call station must be switched to menu mode as described below.
Use in menu mode
In menu mode, the call station and certain elements of the PROMATRIX 8000 system can be
configured via the built-in LC display. In this mode, certain buttons have a different function
than they would in announcement mode. The alternative assignment is specified on the lower
right of the respective button.
1.
2.
3.
Press the ↓ button, keep it held down, and press the ↑ button at the same time. The
display switches from announcement mode to menu mode
Use the call station buttons to navigate through the menu and enter settings. The
following pages contain information about the menu structure
To exit the menu, keep pressing the ESC button until the status display of the
announcement mode appears in the LC display.
Configuration | en
19
28-Feb-2013 | |
Advertisement
Table of Contents
