Resetting The Converter - Allen-Bradley 1203-SSS User Manual

3-10 Configuring the Serial Converter

Resetting the Converter

After you change a parameter, you must reset the serial converter for the
new setting to take effect. You can reset it by removing and then
reapplying power or by using P5 - [Reset Adapter].
ATTENTION: Risk of injury or equipment damage exists. If the serial
converter is transmitting control I/O to the SCANport product
!
(indicated by a solid green diamond LED), the SCANport product may
fault when you remove or reset the serial converter. Determine how
your SCANport product will respond before removing or resetting a
connected serial converter.
To reset the converter
1. In the main menu
2. Press ↑ or ↓ to scroll to P5 - [Reset Adapter].
Figure 3.10 Reset Parameter
Press the UP ARROW or DOWN ARROW key to scroll
through the parameter list. Press the LEFT ARROW or
RIGHT ARROW key to modify parameter values. Press
the ENTER key to save a new value.
5> Reset Adapter = Enable
3. Press → or ← to scroll to Enable, and then press Enter to reset the
converter.
(Figure 3.6), press 1 to display the parameters.