Offset Stack - Sharp AR-407 Operation Manual

FINISHER (AR-FN2)

Offset stack

OUTPUT
TOP TRAY
OFFSET
TRAY
OFFSET
AUTO
3
2
1
3
2
1
7-20
In the initial setting, the top tray is selected.
To select the offset tray, press the OUTPUT key and then the
"OFFSET TRAY" key on the touch panel.
If the offset tray is selected, each copy set will be offset by a minimum
of 15 mm for A4 paper (61/64 inch for 8-1/2" x 11" paper).
SO
When the offset stack function is disabled, copies will not be offset.
The offset stack function can be enabled or disabled by pressing the
"OFFSET" check mark box on the touch panel.
When the STAPLE SORT mode is selected, the offset stack function
AUTO
will be disabled.
If the offset tray is selected, only A4 (8-1/2" x 11") paper can be used.
The top tray cannot be used to offset copies.
OFFSET mode
When copying in the SORT mode, each collated set of
copies will be stacked offset a minimum of 15 mm
for A4 paper (61/64 inch for 8-1/2" x 11" paper) from the
previous set. When copying in the GROUP mode, copies
will be offset and stacked in groups of multiple copies
from the same original.
NON-OFFSET mode
All copies will be aligned in one stack in the offset tray or
the top tray with no offset.